1.       Insert key in the ignition and leave in the OFF position.

  2.      Locate the OBDII  Port under drivers side dashboard.
   (Note port is wider at top) Your OBDII Port will not have numbers, use this for reference.

To be on the safe side ,connect a (5 amp) fuse to a paper clip and use it as a jumper wire in the next step.

   3.      Make sure there are metal contact pins in terminals 8 and 4. Connect 8 and 4 with the 5amp  jumper wire (leave the jumper wire connected throughout the programming procedure).  Make sure you know which terminals are 8 and 4. The vehicle will respond by locking then unlocking the doors to signify entering of programming mode.

4.   Close Doors 

  5.      Turn ignition to the ON position (as far as you can go without cranking the engine).

      Doors will lock.      

  6.      Press and hold both the LOCK and UNLOCK buttons together on the first transmitter to be programmed. Up to about 30 seconds, the vehicle will respond by locking then unlocking the doors. Release the buttons on the transmitter.

  7.      Within one minute, repeat the previous step on the remaining transmitter (if any – including any existing remotes).