GENERAL MOTORS

   To Originate A New Master Key.

   1- Insert new key into ignitio cylinder and turn it to

   the (RUN) position. The security light on the dash

    will illuminate and stay on for ten minutes.

    2- when the security light goes out,you have one

    minute to start the next step.

    Turn the ignition cylinder to (OFF) and then back

    to the (ON) position. The security light on the

    dash will illuminate and stay on for ten more

    minutes.

    3- When the security light goes out, you have one

    minute to start the next step.

    Turn the ignition cylinder to (OFF) and then back

     to the (ON) position. The security light on the

     dash will illuminate and stay on for ten more

     minutes.

     4- After the security light has gone off for the

     third time, the key has been programmed into

     the vehicle's computerand will operate the car.

     It has replaced ALL previous electronic key codes

     and is the ONLY key programmed into the

     vehicle's computer.

---------------------------------------------------------------------------

       TO ADD A DUPLICATE KEY

      1- Insert an existing key and turn the ignition

      cylinder to ON (RUN) and then back to OFF.

      2- Within 15 seconds remove the existing key,

     and insert the new key and turn it to ON.

     3- The security light will light up for two seconds

     to indicate successful programming of the new

     key into the vehicle.