NOTES:
    The system accepts up to three transmitters.
    The transmitter codes are stored in a stacking-type memory.
    If a fourth transmitter code is programmed, the code for the first   Transmitter is erased.
• Entering the programming mode cancels all learned transmitter codes,
so none of the previously programmed transmitters will work.

  You must :
reprogram all of the transmitters once you are in the programming mode.
• You must complete each step within 4 seconds of the previous step to keep the system from exiting the programming mode. Program the transmitters within 10 seconds.

Programming the Transmitter

1. Turn the ignition switch to ON (II).
2. Press the “Lock” or “Unlock” button on one of the transmitters.
   (An unprogrammed transmitter can be used for this step.)
3. Turn the ignition switch to LOCK (0).
4. Repeat steps 1, 2, and 3 two more times using the same  transmitter used in step 2.
5. Turn the ignition switch to ON (II).
6. Press the “Lock” or “Unlock” button on the same transmitter.
  Make sure the power door locks cycle to confirm that the system is  in programming mode.
7. Within 10 seconds, press the “Lock” or “Unlock” button on each transmitter to be programmed.
Make sure the power door locks cycle after you press each transmitter
button to confirm that the system accepted the transmitter’s code.
8. Turn the ignition switch to LOCK (0) to exit the programming mode.