Mitsubishi Remote Programming

 

   1. Locate the Data Port under drivers side dashboard

       usually  located to the right of steering column.

 

   2. Insert keys in ignition and leave in the OFF position.

   3. Make sure there are metal contact pins in terminals 1 and 4

       and connect the Data Port terminals 1 and 4 with a

       5 (amp) fused jumper wire, leave the jumper wire connected

       throughout the programming procedure. Make sure you

       know which terminals are 1 and 4.

    4. Within 10 seconds after connecting the jumper wire,

        press the  Hazard Switch 6 times. Note: The doors will

        automatically lock and unlock once at this time indicating

        that the system is in the programming mode.

    5. Press the LOCK button on the remote to be registered three

        times within 10 seconds. Upon successful

       programming, the door will lock and unlock once.

    6. Repeat step 5 with up to 4 remotes (including any existing

       remotes) within one minute. After completing each

       programming, the doors will lock and unlock once.

    7. Disconnect the programming wire and remove the keys

      from the ignition.

    Disclaimer