1. Start with key out of the ignition, driver door is open  and driver door is unlocked. (all others doors are closed).  

2. Insert key into the ignition (don’t turn it) and pull it out

3. Perform these steps within 40 seconds:

a. Using the power lock switch on the driver’s door, perform 5 lock/unlock cycles with lock. Use an even pace and try to go about one cycle per second. 1 cycle = (1 lock and 1 unlock)

b. Close, then open driver’s door.

4. Perform these steps within 40 seconds:

a. Using the power lock switch on the driver’s door, perform 5 lock/unlock cycles starting with lock. Use an even pace and try to go about one cycle per second. (1 cycle = 1 lock and 1unlock)

b. Insert the key in the ignition cylinder.

c. Turn the ignition to ON (as far as you can without cranking the engine) then back to OFF.

d. Turn the ignition to ON (as far as you can without cranking the engine) then back to OFF.

e. Remove the key from the ignition.

5.Within 3 seconds, the power door locks should cycle automatically indicating successful entry into programming mode. Return to step 1 if the locks do not cycle at this point.

6.Perform these steps within 40 seconds:

a. Press the lock and unlock buttons on the transmitter simultaneously for 1 second.

b. Immediately after letting go of the lock and unlock buttons, hit the lock button by itself and hold for 2 seconds. Within 3 seconds, the door locks should cycle once indicating successful programming. If the door locks don’t cycle, or cycle twice, repeat steps a and b-your remote has not been accepted.

c. Repeat steps a and b in step 6 for each new   transmitter.

7. Close driver door.