1. Start with key out of the ignition, driver door is open (all others closed),
and driver door is unlocked.

2. Insert key into the ignition (don’t turn it) and pull it out

3. Perform these steps within 40 seconds:

a. Using the power lock switch on the driver’s door, perform 5 lock/unlock cycles  with lock.

Use an even pace and try to go about one cycle per second. 1 cycle = 1 lock and 1 unlock)

b. Close, then open driver’s door.

4. Perform these steps within 40 seconds:

a. Using the power lock switch on the driver’s door, perform 5 lock/unlock cycles starting with lock.
Use an even pace and try to go about one cycle per second. (1 cycle = 1 lock and 1unlock) 

b. Insert the key in the ignition cylinder.

c. Turn the ignition to ON (as far as you can without cranking the engine) then back to OFF. 
    

d. Remove the key from the ignition.

5.Within 3 seconds, the power door locks should cycle automatically indicating successful entry
into programming mode.
(Return to step 1 if the locks do not cycle at this point.)

6. Perform these steps within 40 seconds:

a. Press the lock and unlock buttons on the transmitter simultaneously for 1 second.

b. Immediately after letting go of the lock and unlock buttons, hit the lock button by itself and 
hold for 2 seconds.

Within 3 seconds, the door locks should cycle once indicating successful programming.
If the door locks don’t cycle, or cycle twice,that means your remote has not been accepted repeat steps (a and b)

c. Repeat steps a and b in step 6 for each new transmitter.

 

7.   Close driver door. 

 

  Disclaimer